Navigation

White Papers


[pdf] Surge Protection Optimized for HEMP Threats - It’s not just something from science fiction. High-altitude electromagnetic pulse (HEMP) is a threat that government organizations, military agencies, communications leaders, and network engineers co...
[Share This] [Print]

[pdf] Fuse Less SPD Technology - Application Note - Transtector Systems incorporates thermally protected Metal Oxide Varistor (MOV) technology in I2R 75K Series AC surge protection devices (SPDs) to improve safety of SPDs for both personnel and infras...
[Share This] [Print]

[pdf] EMP - A Burgeoning Threat in Todays Technological World - An Electromagnetic pulse or EMP is a burst of radiation created by a high-altitude nuclear explosion. The range and extent of damage this type of destructive event would cause to commercial networks ...
[Share This] [Print]

[pdf] AC & DC Power Protection For Communication Sites - The incidence of damage to equipment in general is higher from power line surges than by any other I/O port. This is not to say more energy comes through the power line, just that the damage is more v...
[Share This] [Print]

[pdf] Coaxial Cable Lightning Protectors - Antenna manufacturers utilize shunt-fed dc grounded antennas as a means of impedance matching and providing some form of lightning protection to their customers. It has been proven that these antennas...
[Share This] [Print]

[pdf] Coaxial Cable Protection - Skin effect is a physical phenomenon that relates to the limited penetration into a conductor of a RF signal, according to its frequency. This effect is present in coax cable, keeping the RF signal in...
[Share This] [Print]

[pdf] Corrosion Protection for Tower Structures - Corrosion Protection for Tower Structures. Most people have a tendency to use copper as for grounding because it is a good conductor, and one of the more noble metals. However, it does have a signific...
[Share This] [Print]

[pdf] Dissimilar Metals may Take Away Your Protection - There are many different types of metals and each has desirable properties. However, when two dissimilar metals are joined to make an electrical connection there can be problems. Corrosion will begin ...
[Share This] [Print]

[pdf] Earth Ground Measurements - Any properly applied lightning protection device is only as effective as the ground system attached to it! Ground resistance (impedance) is usually measured using the 3-stake fall of potential method....
[Share This] [Print]

[pdf] Equipment Rack Grounding - Equipment racks and cabinets can provide an unwanted path for lightning surge energy. The common practice of bringing the antenna cable into the top of the cabinet and securing (bolting) the cabinet t...
[Share This] [Print]

Displaying results 1-10 (of 44)
 |<  < 1 - 2 - 3 - 4 - 5  >  >| 

Newsletter Signup